aj mccormack and son pavingexpert.com

Paving at Corners
On This Page...

How to cope with changes of fall when paving around corners

paving around corners
Related Pages



Dealing with falls when a pathway rounds a corner seems to baffle many people, but it's actually quite simple, once the basic principles are understood. This page examines those basic principles by using worked examples.
In most cases, paths 'flow' around the corner, maintaining pattern and/or alignment as far as practical, as though the paving had been cut from a template sheet. The most common exception is a runout corner, where one branch of the path continues straight across the second branch, until it runs out at the edge of the path. At a runout corner, the fall on the main path can change direction to match that of the secondary path.
run out corner
Runout Corner - Plan View
run out corner xs
Cross-section along line A-A'
The importance of fall on paving is explained elsewhere on this website, so it should be obvious why the need to maintain fall as a path turns a corner is so critical. On most pathways around a house or other property, the fall is primarily crossfall: surface water is directed away from the property. This is an incredibly simple solution, and simple is usually best.
cross-section through path
Cross-section through typical pathway
However, when two such paths meet at an angle, how can there be crossfall at the intersection? The direction of fall on one path conflicts with that on the other. If the two paths are viewd as planes, it can be seen that there would be fairly obvious lips or trips formed where the planes intersect.
paving as planes
Paving planes showing potential lips
This conflict is resolved by gradually folding the paving, changing crossfall through 90° (or whatever is the angle of the corner) to create a smooth and barely noticeable change of direction.
3D view of paving at corners
3D view of how paving at the corner has to be 'twisted' to accommodate fall in two directions
In terms of setting-out, the level of the paving against the building (the inner edge) is self evident. The paths have to meet at the same level. The outer edge of the paving follows the same plane as the inner edge, albeit at a lower level. Where the two paths meet the individual planes to which each should be laid will intersect.

Where both paths are of the same width and/or have the same amount of crossfall, a string line used as a level guide for the outer edge of one path will be at the same level as a string line set for the outer edge of the second path.

string lines at corners
Setting out lines at a corner
cross-section in two directions
Cross-section showing fall in two directions
In principle, this results in the paving units being laid to a gradually changing plane, folding over to meet the plane of the other path. It's worth noting that this folding of rigid paving units can often result in 'lips' on the paving unit as the direction of fall is rotated. Larger units will result in larger lips, so, as with all folded paving, it's better to use smaller units if at all possible. In exceptional cases, larger units may need to be diagonally cut to alleviate significant lips.
diagonal cuts
Larger units often require diagonal cuts to cope with being folded over a change of direction in fall
ramped blocks
Smaller units, such as block paving, are better able to accommodate even quite dramatic changes in levels
So: in essence, when paving pathways around corners, look to maintain crossfall as far as practical, and accept that, unless there is a definite mitre line, such as at a 45° turn, the paving units will need to be twisted or folded to accommodate the change in fall direction.
fall at corners
Schematic illustration of fall at corners